Creating Objects in the Target Domain
A. Refresh
the MA for Source Domain
1. Click
the Management Agents button in Identity Manager
2. Select
the Source Domain MA and click Run under Actions to the right
3. Select
?Refresh Metaverse? under Run profiles and click OK
4. Click
Yes on the warning below
5. Wait
for the ?State? to go to Idle
B. Export
objects from the metaverse to the target domain
1. Review
objects currently in the target OU in the target domain
a. Open
the target OU in ADU&C and make a note of its contents
?
In my environment, I had the following:
2. Select
the Target Domain MA and click Run under Actions to the right
3. Select
?Export to AD? under Run profiles and click OK
4. Click
Yes on the warning below
5. Wait
for the ?State? to go to Idle
6. Click
Adds under Export Statistics
?
In my environment, I had three objects projected in the metaverse
that did not exist in the target domain, and two that I had manually created,
TEST123 & TEST456.? The numbers you see for Adds, Updates, and Renames will
vary based on the number of objects in the source domain OU selected in the
Source Domain MA, and those that have already been manually created in part 2
of this article series.? I had manually created two objects, which had CNs of
TEST123 & TEST456.? These were then renamed, by the rules extension, to
have the same CN as the source object they are linked to in the source domain.
7. Review
objects currently in the target OU in the target domain
a. Open
the target OU in ADU&C and make a note of its contents
?
In my environment, I had the following:
